Description:

711M Block with new Liners Standard Ford Crank with fresh Grind (.010/.010") Re-faced & lightened Flywheel with new Ring Gear, Crank/Flywheel assembly balanced, 2737ECon Rods lightened & balanced with new Small End Bushes, Oil Pump  with new 1" Scavenge Rotor & 3/4" Scavenge Pipe. Cylinder Head has new Valve Guides & new Unleaded Exhaust Seats, Carb has usual FF mods & settings.

Comes complete with the following new parts..........Pistons (Mahle/FFI) Mah;e Main & Big End Bearings, Thrust Washers, Cam Bearings, FFI Camshaft, Cam Followers, Cam Thrust Plate, Spigot Bearing, Crank Sprocket, Timing Chain, Damper Pad, Oil Thrower, Water Pump, Toothed Belt Drive Kit, HD Big End Bolts, Flywheel Bolts, Clutch Cover, Clutch Plate, Distributor, NGK HT Lead Set, Spark Plugs, Fuel Pump, FFI Inlet & Exhaust Valves, Valve Springs, Rocker Shaft, Core Plugs, Oil Gallery Plugs, Full set standard hardware bolts, nuts & washers, Head Dowels, Bell Housing Dowels, All Gaskets & Oil Seals. etc. 

Just requires assembling (will need block deck machining to set compression ratio & rocker pads re-profiling to maximize valve lift)

Nothing is missing

All this for £3900.         (could supply fully built for additional £900)