Race & Rally Parts
Apex GT4 Steering Wheel
Apex GT4 CAN Enabled Steering Wheel, chassis is machined from a single block of 6061 grade aluminium and anodised black. The handgrips are made of carbon fibre coated with a military grade rubber coating.
Fitted with a CAN board for direct communication to your car’s ECU. The wheel can be configured in many ways utilising the 8 push buttons inputs and 8 analog inputs on the CAN board. A typical set up would be 10 push buttons and two rotary switches.
The specification of the CAN board is as follows -
CAN BUS 2.0B
500 or 1000kbps, user selectable
Different CAN ID and CAN frame structures can be selected
8 switch inputs (switched to ground)
8 analog inputs / rotary switch inputs, 0-5V, 10bits
4 low side outputs (0.5A, resistive and inductive loads)
+5V output for powering rotary switches, sensors and potentiometers
Firmware upgrade over the CAN bus
The Apex GT Steering Wheel has a diameter of 290 mm and the ergonomically designed hand grips make this a really user friendly steering wheel. It can be customised in many ways with additional buttons, rotary switches and encoders.
Compatible with both 70mm 6 bolt and 50.8mm 3 bolt PCD.
The price shown is for the model fitted with the CAN board as described above.
Get in touch for further options